Gravity Sparge Arm

Gravity Sparge Arm

Item currently out of stock

This is a real simple gravity sparge arm. This is designed to work with a 1/2" FPT ball valve on the HL Tank. The kit comes with a 1/2" MPT stainless fitting. The sparge arm is all copper with small holes drilled into the the top of the ring for gentle sparging. Screws on and off the HL tank for easy use and removal. The ring is held on by a removable small clip for easy cleaning.
Approximately 9" in diameter.

Community Q&A

Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 3 questions Browse 3 questions and 4 answers
Why did you choose this?
MoreFlavor Store
Experimenting with different sparge options
Dylan on Oct 9, 2018
Experimenting with different sparge options
Dylan on Oct 9, 2018
To sparge from a gravity tank
Scottie M on Oct 4, 2018
To sparge from a gravity tank
Scottie M on Oct 4, 2018
Can this be used with a pump?
Roy Reagan on Dec 3, 2018
BEST ANSWER: Yes but make sure the grain bed is set first in a HERMS or RIMS set up otherwise the grain will clog it easily
What's the maximum extension of the vertical portion? I sometimes need as much as 16-17" of rise when doing a 5gal batch in my 15.5 gal "keggle" mash tun. I think the 9" rise is enough when doing a 10gal batch.
David Pratt on Feb 18, 2019
BEST ANSWER: Hi David - The vertical portion is 10".
What's the inside diameter of the copper tubing?
David Pratt on Feb 18, 2019
BEST ANSWER: 215mm or 8.5”

4.0 / 5.0
4 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
Inexpensive and works very well. My efficiency has gone from 65 to 79% by switching from batch to fly sparging using this arm.
August 22, 2018
1 year ago
Response from MoreFlavor
September 7, 2018
Zach R Staff
Not bad
Only used it once, but on low flow it only comes out the holes closest to the Mash Tun outlet so holes on outside don't populate. Looks like a little bending might fix this, but I didn't want to do that. As soon as you turn up the flow, then it comes out all the holes.
It comes with three different lengths of pipe. Make sure you don't get it too low in your Mash Tun, or it will be submerged...

I was confused when I first got it because the holes are on top of the device. I think that's the design, but seemed weird to me at first.

May 22, 2017
Simple & Effective
Bought this to replace a plastic drilled sparge arm and I have to say this thing works great. if you have a gravity setup its perfect. controls the flow of water nicely with the ball valve, nice slow sprinkling of the sparge water, and because its copper your sparge water will stay relatively the same temp throughout the sparge. Great for the price. only con I have for it is its copper, needs a nice soaking in starsan before each use to clean the tarnish off of it.
April 13, 2016
Gravity sparge
This sparge arm is great for the price. I installed it into my MT's lid and it works great with the pump (just have to be careful and put a valve on the outlet of the pump to control the flow going to the arm).
May 27, 2015