A must-have tool for any DIY draft-cleaning system, the Faucet Cleaning Adapter makes it a cinch to back-flush your draft lines for cleaning. Simply remove your draft faucet and mount the adapter in its place, leaving you with a 3/8” barb to connect tubing.
This is a hard one to review. It does what it's supposed to and seals well. I used it to marry up with the sanke cleaning adapter for a homemade cleaning system that will clean beer line, sanke tap, and faucet, all at once.
I would recommend this combination of parts to adapt my Perlick spouts. I like the ease of cleaning my lines from the spout down to the keg connector. I don’t like that it’s three pieces you have to hold together while hooking it up to the tower. If the gasket pressed into the threaded housing and held all three together it would be a much better design.
The washer on this is too small to actually seal with my shank (#D1245). All the liquid just drips out at the connection. Centering the washer with a piece of wire solves the problem, but I really shouldn't have to engineer such a solution.
.png)
.png)
(1).png)
.png)
